2.3.4_Small LITHIUM METAL BATTERIES CONTAINED IN EQUIPMENT FOR DISPOSAL OR RECYCLING Small batteries excepted UN 3091 Applies to: Lithium metal batteries contained in equipment with a lithium content not more than 2 g/battery UN No., Proper Shipping Name UN 3091, LITHIUM METAL BATTERIES CONTAINED IN EQUIPMENT Class 9 Packing Group Not assigned Hazard Label Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced not less then 30mm by 30mm on small packages. • They must have a line 5 mm inside the edge and running parallel with it. Prerequisite • For road transport, batteries do not need to meet the General Requirements of §173.185(a) in particular the test requirements Transport mode Road Marine Air Passenger Aircraft Cargo Exemption conditions 173.185(d) P909 Forbidden Forbidden Devices must be protected so as to prevent short circuits, including protection against contact with conductive materials within the same packaging that could lead to a short circuit. Packaging Drums, Jerricans, Boxes; not required UN approved packaging Weight limit 30 kg Gross 30 kg Gross Marking and Labelling of Packages Li Batt Mark minimum dimensions: 100 × 100 mm, for small packages reduced to 100 mm × 70 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document is not required Transport document is not required May reac and with Spilled su Risk to t system. 8 Miscellaneous dangerous substances and articles Risk of b Risk of fi Risk of e Risk to t system. 9 9A NOTE 1: For dangerous goods wit NOTE 2: Additional guidance show goods to be carried and their means of t 8 9 International Transport Regulations Small Excepted Lithium battery mark Applicable until 31.12.2026 Applicable from 1.1.2023 Lithium battery mark A rectangle or a square of minimum dimensions 100 x 100 mm and the minimum width of the hatching shall be 5 mm. The symbol shall be black, the hatching shall be red. If the size of the package so requires, the dimensions may be reduced to not less then 100 x 70 high. The rectangular mark 120 x 110 mm dimension may continue to be used. For IATA DGR, the character of the UN numbers shall be at least 12 mm height Handling Labels Cargo Aircraft Only for IATA DGR Minimum dimensions 120 x 110 mm 172 Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==