2.3.2_Full LITHIUM METAL CELLS CONTAINED IN EQUIPMENT FOR DISPOSAL OR RECYCLING Fully regulated cells UN 3091 Applies to: Lithiummetal cells contained in equipment with a lithium content in excess of 5 g/cell UN No., Proper Shipping Name UN 3091, LITHIUM METAL BATTERIES CONTAINED IN EQUIPMENT Class 9 Packing Group Not assigned Hazard Label Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced not less then 30mm by 30mm on small packages. • They must have a line 5 mm inside the edge and running parallel with it. Prerequisite • For road transport, cells do not need to meet the General Requirements of §173.185(a) in particular the test requirements Specific Requirements • Each cell incorporates a safety venting device or is designed to preclude a violent rupture under normal conditions of carriage; • Each cell is equipped with an effective means of preventing external short circuits Transport mode Road Marine Air Passenger Aircraft Cargo Packing instructions 173.185(d) P909 Forbidden Forbidden • Cells and devices must be protected against short circuit, including protection against contact with conductive materials within the same packaging which could cause a short circuit. • Devices must be packed so that are protected against damage caused by themovement or placement of the cells within the packaging Packagings UN Packaging not required, strong outer packaging is authorized UN Packaging not required, strong outer packaging is authorized Cells ≥ 12 kg (gross) with a strong, impact resistant outer casing Not required UN approved packagings for cells, or assemblies of such cells, when packed in strong outer packagings or protective enclosures (e.g., fully enclosed or wooden slatted crates) Allowed transport on Pallets or other handling devices. Cells must be secured to prevent inadvertent movement, and the terminals must not support the weight of other superimposed elements Large Packaging 173.185(b)(6) LP903 Rigid Large packagings, conforming to the packing group II performance level, are authorized for a single battery.: • steel (50A); • aluminium (50B); metal other than steel or aluminium (50N); • rigid plastics (50H); • natural wood (50C); • plywood (50D); • reconstituted wood (50F); • rigid fibreboard (50G). Weight limit No limit No limit Marking and Labelling of Packages UN 3091 LITHIUM METAL BATTERIES CONTAINED IN EQUIPMENT UN 3091 LITHIUM METAL BATTERIES CONTAINED IN EQUIPMENT Overpack: OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document Transport document 152 Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==