2.3.8_Small LITHIUM ION BATTERIES CONTAINED IN EQUIPMENT FOR DISPOSAL OR RECYCLING Small cells excepted UN 3481 Applies to: Lithium ion batteries contained in equipment with a Watt-hour rating not more than 100 Wh/battery UN No., Proper Shipping Name UN 3481, LITHIUM ION BATTERIES CONTAINED IN EQUIPMENT Class 9 Packing Group Not assigned Hazard Label Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced not less then 30mm by 30mm on small packages. • They must have a line 5 mm inside the edge and running parallel with it. Prerequisite • For road transport, batteries do not need to meet the General Requirements of §173.185(a) in particular the test requirements Transport mode Road Marine Air Passenger Aircraft Cargo Exemption conditions 173.185(d) P909 Forbidden Forbidden Batteries and devices must be protected against short circuit, including protection against contact with conductive materials within the same packaging which could cause a short circuit. Devices must be packed so that are protected against damage caused by the movement or placement of the cells within the packaging Packaging Drums, Jerricans, Boxes; not required UN approved packaging Weight limit 30 kg Gross 30 kg Gross Marking and Labelling of Packages Li Batt Mark minimum dimensions: 100 × 100 mm, for small packages reduced to 100 mm × 70 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document is not required Transport document is not required Corrosive substances Risk of bu May reac and with o Spilled su Risk to th system. 8 Miscellaneous dangerous substances and articles Risk of bu Risk of fir Risk of ex Risk to th system. 9 9A NOTE 1: For dangerous goods with NOTE 2: Additional guidance show goods to be carried and their means of tr 8 9 International Transport Regulations Small Excepted Lithium battery mark Applicable until 31.12.2026 Applicable from 1.1.2023 Lithium battery mark A rectangle or a square of minimum dimensions 100 x 100 mm and the minimum width of the hatching shall be 5 mm. The symbol shall be black, the hatching shall be red. If the size of the package so requires, the dimensions may be reduced to not less then 100 x 70 high. The rectangular mark 120 x 110 mm dimension may continue to be used. For IATA DGR, the character of the UN numbers shall be at least 12 mm height Handling Labels Cargo Aircraft Only for IATA DGR Minimum dimensions 120 x 110 mm 204 Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==